How radar can help prevent fatalities on the road and at your jobsite

The construction industry is a huge business, generating millions for the economy every year and ensuring that infrastructure and development in key areas such as health, education and transport are maintained.
 
With the rapidly growing demand for residential and commercial building comes an increase in the number of heavy construction vehicles using road networks. This includes driving in busy cities and built-up areas where they are more likely to come into contact with vulnerable road users. As a result, this has put pressure on the industry to ensure other road users, in particular cyclists and pedestrians, remain safe and that fatal collisions are prevented.
 
The heavy vehicles and equipment used by the construction industry, such as dumpers, cement mixers and tippers, pose a danger if they are not managed safely. Blind spots tend to be much larger on these vehicles and include not only the rear and nearside but also the front, especially with elevated driver positions.
 
According to research carried out by the Canadian Council of Motor Transport Administrators in 2017, of the 1,841 deaths on Canada's roads, 15.4 percent were pedestrians, 10.4 percent motorcyclists and 2 percent cyclists. The data also revealed that the number of collisions recorded increased during the winter months, when icy roads and blizzards make driving conditions more difficult.
 
Blind spots on vehicles, along with poor visibility due to bad weather conditions, are a major contributing factor to collisions and are often the main reasons why pedestrians and cyclists are killed or injured.
 
Safety for larger vehicles has dramatically improved in recent years, with many operators opting to invest in stringent safety procedures, including fitting vehicle safety systems to eliminate vehicle blind spots.
 
For drivers in the construction industry, detecting objects and people in blind spots is crucial to safety not only on the road, but also on worksites where ground workers are at risk from moving vehicles and machinery.
 
Sensing hazards

Radar obstacle detection technology can detect stationary and moving objects even in the harshest of environments. It gives the driver an audible and visible warning when objects are within a certain distance. One such system, which is unique to Brigade Electronics, is its Backsense Radar. It uses Frequency Modulated Continuous Waves (FMCW) technology, transmitting a continuously varying radar frequency signal with time stamps unique to each instance of the wave. The time of the returning wave is referenced to the stamp without the radar needing to pause transmission. This provides more accurate detection than alternative radar products that use pulsed radar technology, which instead transmit a burst of radar and then listen for the returning wave.
 
Distances on Backsense can also can be programmed to suit different-sized vehicles and applications, from 6.5 feet to 33 feet in width and 10 feet to 98 feet in length. Bespoke detection areas can also be set to calibrate-out fixed objects or bodywork.
 
The data provided by radar obstacle detection can be combined with an on-screen display and fed back to the driver via an in-cab monitor. Ideal for vehicles maneuvering at low speed, the on-screen display warns the driver of obstacles in the danger zone by overlaying five-stage audible and visual radar data onto a camera image on the monitor. This informs the driver of the distance between the vehicle and obstacles.
 
Due to the number of complex blind spots on large vehicles, a single radar cannot always provide the levels of detection required. This is why Brigade introduced its network radar system, which enables up to eight sensors to be connected and linked to a single in-cab display. This limits distractions for the driver and further enhances safety by ensuring complex blind spots are eliminated.
 
Radar obstacle detection is suitable for both on and off-road applications, so even on specialist vehicles it offers first-class protection, preventing collisions and saving lives.

Of course, technology is just one step toward preventing deaths and solving safety issues. Alongside this, operators need to ensure that there are robust procedures in place and that they are committed to implementing and executing these to ensure they are doing as much as possible to keep everyone safe.